Axisymmetric thermoelastoplastic stress-strain state of flexible laminated transversely isotropic shells

The paper presents a technique for numerical analysis of the elastoplastic stress-strain state of flexible laminated shells of revolution made of isotropic and transversely isotropic materials and subjected to axisymmetric loading and heating. The technique is based on the Kirchhoff-Love hypotheses for the whole laminate. The deformation of the isotropic materials is described using the theory of deformation along paths of small curvature. The deformation of the transversely isotropic material is described using the flow theory with isotropic hardening. The process of loading is divided into steps at each of which the stress-strain state is determined by the method of successive approximations. A numerical example is given __________ Translated from Prikladnaya Mekhanika, Vol. 42, No. 12, pp. 76–86, December, 2006.     

Thermoelastoplastic axisymmetric stress-strain state of laminated orthotropic shells

A method is proposed for the numerical analysis of the thermoelastoplastic stress-strain state of laminated shells of revolution, made of isotropic and orthotropic materials, under axisymmetric loading. The method is based on the Kirchhoff-Love hypotheses for a layer stack, the theory of deformation along paths of small curvature for isotropic materials, and Hills theory of flow with isotropic hardening for orthotropic materials. The problem is solved by the method of successive approximations. A numerical example is given.__________Translated from Prikladnaya Mekhanika, Vol. 40, No. 12, pp. 84–91, December 2004.     

添加剂与RDX的界面作用及对撞击感度的影响研究

研究了石蜡、硬脂酸等添加剂与RDX的界面作用及其对撞击感度的影响。得出添加剂对RDX(Hexogen)的铺展系数越大,钝感效果越好的结论,并获得了铺展系数与特性落高的经验函数关系。     

Rolling of a Rigid Cylinder over a Half-Plane with Initial Stresses (Harmonic and Bartenev–Khazanovich Potentials)

An asymmetric quasistationary problem for a prestressed half-plane with harmonic and Bartenev–Khazanovich potentials is solved based of the linearized theory of elasticity. The Mehler–Fock integral transform is used to solve the differential equations that describe the stress–strain state of the half-plane. The dependences of the normal and tangential stresses and stress intensity factors on the elongation are plotted     

增韧环氧树脂的动态裂纹扩展研究

本文主要进行了环氧及增韧环氧树脂的断裂韧性及裂纹快速扩展的试验研究。试验过程中采用了ＧＬＣ－１型高速裂纹扩展测试仪来测试裂纹的扩展速度,得到在裂纹扩展过程中裂纹扩展速度曲线。本文结合不同的计算公式及有限元分析方法,讨论了各个确定断裂韧性公式的准确程度,发现传统的静态断裂韧性的分析方法所得到的结果偏大,有一定的危险性,建议使用试验与数值计算相结合的方法;同时还发现增韧不仅可以提高材料的静态和动态断裂性能,而且在裂纹扩展过程中可以起到减缓裂纹扩展的作用     

类升力体外形高超声速粘性绕流拓扑结构分析

采用交替方向隐式分解的隐式NND格式求解全N-S方程模拟“类升力体”外形在高超声速下的大攻角流动,给出了“类升力体”外形表面极限流线随攻角变化的拓扑结构及40°攻角下垂直于体轴的横截面流线拓扑结构。结果表明:类升力体外形三维流场结构十分复杂,攻角从0°～40°变化时,背风面表面极限流线依次由不分离、开式分离向起始于鞍、结点组合的高阶奇点的分离方式转化,翼面横向分离亦随攻角增大而增大;垂直于体轴的横截面流动拓扑结构与文献[2]给出的理论分析一致。     

Localized solutions to the nonlinear wave equation for flexural motions of an elastic beam traveling in an air-filled tube

Steady-progressive-wave solutions are sought to the nonlinear wave equation derived previously [J. Fluids Struct. 16 (2002) 597] for flexural motions of an elastic beam traveling in an air-filled tube along its center axis at a subsonic speed. Fluid-structure interactions are taken into account through aerodynamic loading on the lateral surface of the beam subjected to small but finite deflection but end effects and viscous effects are neglected. Linear dispersion characteristics are first examined by exploiting the small ratio of the induced mass to the mass of the beam per unit length. Centered around the traveling speed of the beam, there exists such a narrow range of propagation velocity that the linear steady propagation is prohibited. In this range, it is revealed that some interesting nonlinear solutions exist. The periodic wavetrain is found to exist as the exact solution. Asymptotic analysis is then made by applying the method of multiple scales and the stationary nonlinear Schrödinger equation is derived for a complex amplitude. A monochromatic solution to this equation corresponds to the exact periodic solution. Imposing undisturbed boundary conditions at infinity, it is revealed that the localized solution exists as a result of balance between the linear instability and the nonlinearity. This solution is checked by solving the nonlinear equation numerically. It is further revealed that the amplitude-modulated wavetrain exists not only in the range of the velocity mentioned above but also outside of it.     

Study on failure process of delaminated stiffened composite plates under compression

Failure behavior of the delaminated stiffened composite plates under compression is studied by the finite element method, based on a Global-Local variational model. A virtual crack closure technique and a self-adaptive grid moving scheme are proposed to predict the delamination growth process. The contact effect along the delamination front is considered. The numerical results show that the influences of the distribution and location of the stiffeners, the configuration and size of the delamination, the boundary condition and the contact upon the failure behavior of the plates are significant. The project supported by the National Natural Science Foundation of China (59975014)     

Contact Stress Distribution Under a Rigid Cylinder Rolling Over a Prestressed Strip

A nonsymmetric quasistationary problem for a strip with initial stresses is solved under the linearized theory of elasticity for harmonic and Bartenev–Khazanovich potentials. The Hankel integral transform is used to solve the differential equations that describe the stress–strain state of the strip. The dependences of the normal and tangential stresses and stress intensity factors on the elongation are plotted     

Stability of the Sliding Mode in Nonstationary Automatic-Control Systems with Variable Structure

The paper addresses the stability of the sliding mode in nonstationary automatic-control systems of variable structure. The parameters of dynamic states are assumed to vary arbitrarily and continuously within a given bounded domain. The existence and stability conditions for the sliding mode on the switching hyperplane are established. They define nonstationary sets that contain phase velocity vectors directed away from the sliding hyperplane. The sets do not have common points with the switching hyperplane, except for the origin, for the known extreme values of the discontinuous coefficients of logical controls. This is the essence of the necessary and sufficient conditions for the stable sliding mode of the automatic-control system. The general results are used to analyze the stability conditions for the sliding mode in a nonstationary automatic-control system with a variable structure of the third order